Skip to main content

Restoring Backups to IE-3100 Switches

Express Setup

If you get a red flashing LED after pressing express setup, hold express setup button until you get green/red alternating blinks to factory reset (takes 15-20 sec)
Login admin
Password switch
Host Name RIOxxx-SW-LAN-x

Upgrade Firmware

Administration --> Software Management
First, click on Remove Inactive Files
One-Shot Install Upgrade Checked
Source File Path:

Select firmware file from PC

(ie31xx-universalk9.17.15.05.SPA.bin)
Click Download & Install

Administration --> Software Management (After Reboot)
Click one last time on Remove Inactive Files to remove any lingering files after the upgrade.

PRPRestore Configuration (for PCS/SCS Networks)

Administration --> DeviceManagement --> File Manager
  • Double-click
    • thefolder
  • Click
    • uploadand
    Systemflash: MTU 1506
    select the vlan.dat file from your computer you want to restore
  • No confirmation will be given, but the file should upload after a few seconds

    • ConfigurationAdministration --> Layer 2Management --> VLANBackup & Restore

    On the VLAN tab, click on Add+
    VLAN ID2
    NameSCS
    Port Members

    8T2C --> 7-10

    4T2S --> 5-6

    On the SVI tab, click on Add+

    fromyour
    VLAN NumberCopy 2To Device
    DescriptionFile Type SCSConfiguration
    IPv4Transfer Mode CheckedHTTP
    IPv4Backup TypeExisting Startup Config to Flash? StaticNo
    IPv4Source AddressFile Path 192.168.2.x(Select (Sameyour 4thbackup Octetconfiguration asfile VLAN1)
    Subnet Mask255.255.255.0PC)
      Edit
    • Click VLAN1Download withFile
      • the
    • Once followingfile setting.
      • is

      downloaded
      successfully, clickReload
      DescriptionPCS

      Configuration --> Layer 2 --> Smartports
      Interfaces Gi1/1 and Gi1/2 (All Models)
      RoleSwitch
      Native VLAN1
      Interfaces Gi1/3-4 (4T2S)
      RoleEthernet/IP
      Access VLAN1
      Interfaces Gi1/5-6 (4T2S)
      RoleEthernet/IP
      Access VLAN2
      Interfaces Gi1/3-6 (8T2C)
      RoleEthernet/IP
      Access VLAN1
      Interfaces Gi1/7-10 (8T2C)
      RoleEthernet/IP
      Access VLAN2
    Administration --> Industrial Protocols --> CIP
    For diagnostics, we want to enable CIP
    CIP StatusEnable
    CIP VLAN1
    CIP Passwordswitch

    REP Configuration

    Configuration --> Redundancy Protocols --> REP

    Interface Gi1/1-2 (Most Switches)
    EnableEnable
    Segment ID1
    Port TypeNone
    Interface Gi1/1 (Furthest Switch from PLC)
    EnableEnable
    Segment ID1
    Port TypeEdge Primary
    Interface Gi1/2 (Furthest Switch from PLC)
    EnableEnable
    Segment ID1
    Port TypeEdge
    Back to top