Skip to main content

Moxa UC-8100A-ME-T-LX Setup

This details steps to set up a Moxa UC-8100A-ME-T-LX for MQTT Transmission for reliable and consistent communications.

To check the firmware of the Moxa, run the following commands via SSH (login is moxa/moxa):

kversion -a

If the device has the Custom-QTC firmware loaded, it most likely has ThingWorks installed which allows configuration through LAN 2 on IP 192.168.4.127. LAN1 is configured as the WAN port and by default is a static IP at 192.168.3.127. Any network or serial port configuration done via SSH is overwritten by the Web interface on every reboot. Only Ignition installation needs done via the SSH interface.

If using a model without ThingWorks, configuration of network ports is done via the command line (SSH).

To change the network configuration, run the following command:

sudo nano /etc/network/interfaces

By default the portion of the configuration for the network ports will be as follows:

iface eth0 inet static
        address 192.168.3.127
        network 192.168.3.0
        netmask 255.255.255.0
        broadcast 192.168.3.255
iface eth1 inet static
        address 192.168.4.127
        network 192.168.4.0
        netmask 255.255.255.0
        broadcast 192.168.4.255

To set up the top ethernet port for DHCP, modify the file as follows:

iface eth0 inet dhcp
#        address 192.168.3.127
#        network 192.168.3.0
#        netmask 255.255.255.0
#        broadcast 192.168.3.255
iface eth1 inet static
        address 192.168.4.127
        network 192.168.4.0
        netmask 255.255.255.0
        broadcast 192.168.4.255

For checking the serial port configuration, run the following commands to view serial ports 1 and 2 current modes:

sudo mx-uart-ctl -p 0
sudo mx-uart-ctl -p 1

For setting up the serial port configuration, run the following commands to set the ports up for RS-485 2-Wire:

sudo mx-uart-ctl -p 0 -m 1
sudo mx-uart-ctl -p 1 -m 1

For other modes, see the following table:

Mode # Operation Mode
(blank) Display Current Mode
0 RS-232
1 RS-485 2-Wire (Half Duplex)
2 RS-422/RS-485 4-Wire (Full Duplex)
Back to top